Assistance; Demo Mode; Autotest (Testing / Running-In); Autotest Sequence - Indesit MOON 2006 Service Manual

5. ASSISTANCE:

5.1. DEMO MODE:

This machine does not feature the Demo Mode function.
5.2. AUTO TEST:
The Hardware Key (transparent - C0095669) is used to run the EVOII platform Autotest program.
A BLUE led will light up on the hardware key to indicate that the appliance is an EVOII machine. A
fl ashing RED led on the hardware key (when the key is slotted into the machine) indicates that the
electronic PCB is in communication with the hardware key. If the Hardware Key is unable to establish
a connection with the washing machine, the display shows the letters "ERR" in fl ashing mode.
Initial conditions before starting the Autotest procedure
1. Washing machine with no water in tub.
2. Door closed.
3. Switch on the appliance and plug the hardware key into the slot provided.
To start the Autotest procedure, press and release the button marked AUTOTEST. An audible signal
will be emitted and the message "AUTOTEST" will scroll across the display.
Autotest sequence for Washing Machine
- 1 litre of water for wash cycle solenoid valve.
- 1 litre of water for pre-wash solenoid valve
- 1 litre of water for fabric softener solenoid valve
- Movement at 25 r.p.m.
- Water is heated to 28°
- Drain and spin at 800 r.p.m.
- Stop.
IMPORTANT!!: If the washing machine functions correctly but has previously been stopped due to a FAULT,
instead of running the AUTOTEST programme, the FAULT in question will be indicated on the hardware key
display and also on the washing machine display, in various modes depending on the interface type.
Service Manual
MOON - 2006
Edition
2006.06.12
G
Linguage
English
B
16