Storage - Husqvarna Z 242F Operator's Manual

STORAGE

Winter Storage
The machine should be readied for storage at the
end of the mowing season or if it will not be in use
for more than 30 days. Fuel allowed to stand for
long periods (30 days or more) can leave sticky
residues that can clog the carburettor and disrupt
engine function.
Fuel stabilizers are an acceptable option to
prevent the sticky residues that can occur during
storage.
Add stabilizer to the fuel in the tank or in the
storage container. Always use the mixing ratios
specified by the manufacturer of the stabilizer.
Operate the engine for at least ten minutes
after adding the stabilizer until it reaches the
carburettor. Do not empty the fuel tank and the
carburettor if stabilizer has been added.
WARNING! Do not keep an engine with
fuel in the tank indoors or in poorly ventilated
areas where fuel fumes can come in contact
with open flames, sparks, or a pilot light
such as in a boiler, hot water tank, clothes
dryer, etc. Handle the fuel with care. It is very
flammable and can cause dangerous personal
injury and property damage. Drain the fuel
into an approved container outdoors and
keep far away from open flame or sources of
ignition. Do not use gasoline for cleaning. Use
a degreaser and warm water.
To ready the machine for storage:
1. Fully clean the machine, especially under the
mower deck. Touch up damage to the paint
and spray a thin layer of oil on the underside
of the mower deck to avoid corrosion.
2. Inspect the machine for worn or damaged
parts and tighten any nuts or screws that may
have become loose.
3. Change the engine oil; dispose correctly.
4. Empty the fuel tanks or add a fuel stabilizer.
Start the engine and let it operate until the
carburettor is drained of fuel or the stabilizer
has reached the carburettor.
5. Remove the spark plug and put about a
tablespoon of engine oil into the cylinder.
Turn over the engine until the oil is evenly
distributed and install the spark plug again.
6. Lubricate all grease zerks, joints and axles.
7. Remove the battery. Clean, charge and keep
the battery in a cool area and protected from
direct cold.
8. Keep the machine in a clean, dry area and
cover it for more protection.
Service
When ordering spare parts, please specify the
purchase year, model, type, and serial number.
Always use genuine Husqvarna spare parts.
An annual check-up at an authorized service
workshop is a good way to make sure that the
machine performs its best the following season.
29