Advertisement
Whole display
This section explains all the information that may
appear in the display.
Sampling frequency
indicator
Chase mode
indicator
l
Time code indication
"SMPTE" or "EBP
depending on the type of time
code used.
TIME CODE: When a time code is recorded or
reproduced, this indicator lights along with displaying
l
Start
ID write/erase indication
START ID WRITE: This indication appears when a
Start ID is written to a tape.
START ID ERASE: This indication appears when a
Start ID is erased from a tape,
AUTO REC: This indication appears when the
automatic Start-ID writing mode is set.
See sect;011 7-3 "l&/ 1!4rnu
Operations"
(page 7.5).
When a Start ID is read from a tape during playback,
"START-ID" appears.
with the frequency display "25", "7.9.97", or "30".
l
Sync signal indication
SYNC PB: This indication appears when playback is
carried out under the following conditions:
VIDEO: When the unit goes into the mode for video
I) the time code format is other than Film.
2) A video sync signal is input to the REF VIDEO
synchronization,
this indication appears along
INPUT connector on the connector panel.
3) the setup menu "SYNC PB" is set to
"ENABLE?' to lock the off-tape time code and
the input video sync signal in phase.
See
section 7-3 "Dkal Menu Operations"
(page 7-5).
EXT SYNC: When the unit goes into the mode for
external synchronization
(when the SYNC signal
selector is set to EXT), this indication appears
along with the display "D-I" (in the AES/EBU
format) or "WORD" (for a word sync signal)
depending on the type of synchronizing signzdl
used.
(Continued)
Advertisement
