Advertisement
-
While the unit is on, the display shows information
-
relevant to the current state of the unit. Refer to this
-
section
as required.
8
gz
N
Basic display
When you turn on the unit, the display will show
Upon initialization, the basic display showing the
initializing information for several seconds.
factory settings will appear.
The following explains the basic display.
r
L
l
Level meters
l
Sampling frequency indicator
Indicate the audio signal levels.
Shows the sampling frequency (44.1 kHz or 48 kHz).
l
Tape time display area
Shows the tape time or error messages.
When the tape
time is displayed, type of tape time (time code,
absolute time, or counter time) is also indicated.
Figures and alphabet shown in the display
Figures and characters (alphabet) appear as shown
below in the tape time display area and input/set data
display area.
3
DISPLAY key menu display area
Figure
1234567890
Shows the DISPLAY key menu selection.
The initial
Indication
;?3qs6
763E
selection is
"LOCATE POINT". To change the
Alphabet
ABCDEFGH
I JK*LM*N
selection, use the DISPLAY select key.
lndicakm
RbcdEFLH
,J
L
n
Figure
OPQRSTUV*W*X*YZ*
l
Inputiset data display area
Indication
0 pqrstu
3
Shows the data corresponding
to the current DISPLAY
key menu selection.
*These charac&rs do not appear.
l
Chase mode indicator
Shows the chase mode setting.
The unit has been
factory set to RE-CHASE ON (this indicator lights),
Advertisement
