Mitsubishi Electric Q173CPU User Manual page 113

2 SYSTEM CONFIGURATION
(5) Setting of the axis No. and axis select switch of servo amplifier
Axis No. is used to set the axis numbers of servo amplifiers connected to
SSCNET connector(CN ) in the program.
Axis No. of 1 to 32 can be set for Q173CPU(N), and axis No. of 1 to 8 can be set
for Q172CPU(N).
Axis No. is set for each system of SSCNET in the system setting of programming
software. Axis No. (Q173CPU(N):1 to 32/Q172CPU(N):1 to 8) is allocated and
set for the setting axis number (d01 to d8) of servo amplifier.
Since the axis number (d01 to d8) of servo amplifier on the system setting screen
corresponds to axis select switch (0 to 7) of servo amplifier, set the axis select
switch referring to the table of next page.
• System setting (Allocation of axis No.) •
Axis select switch (Servo amplifier)
8
Set the axis No. relative to axis number (dno.).
(Note) : Correspondence between dno. and axis select switch of servo amplifiers is shown in the next
page.
2 - 94