3.4
Wiring
For wiring of the inverter which has one front cover, route wires between the control circuit terminal block
and front cover. If cables can not be routed between the control circuit terminal block and front cover (about
7mm), remove a hook of the front cover and use a space become available.
For wiring of the inverter which has front cover 1 and 2, use the space on the left side of the control circuit
terminal block.
0
0
Front cover
Inverter which has one front cover
REMARKS
⋅ When the hook of the inverter front cover is cut off for wiring, the protective structure (JEM1030) changes to open
type (IP00).
Cut off
with a
nipper,
etc.
Cut off a hook on the inverter
front cover side surface.
(Cut off so that no portion is left.)
0
0
Front cover 1
Front cover 2
Inverter which has front cover 1 and 2
WIRING
3
Control circuit
terminal block
19