Getting Started
The packaging box contains the following items:
-
IR 4468 BT Internet radio
-
Remote control
-
AC power cord
-
3.5 mm adaptor cable
-
3.5 mm to RCA-jack adaptor cable
-
User manual
Get the network ready
• For Wireless LAN (WLAN) connection:
Check if the WLAN LINK / ACT light of the wireless
access point or router is illuminated. Consult its user
manual if there are any questions.
NOTE:
Wi-Fi allows data transfer over short distances within
20 meters without the need of cabling between the
devices. Any walls or ceilings may reduce the strength
of the Wi-Fi connectivity.
Therefore try to locate the IR 4468 BT and / or the
access point within the distance mentioned above,
and avoid any obstacles between two devices.
• Connect the power cord to the AC socket (14) on the
backside of the appliance.
• During the initial start of the appliance, the system will
ask you to set Language and Network Configuration.
• First screen: Select “Yes” to check for networks when
turning on the alliance.
• Second screen: Select “Yes” in the second screen to
establish the connection with the network.
• Select “Yes (WPS)” (only for WPS routers). Then press
the WPS button on your router.
• Select “No” if you prefer to listen to a terrestrial station
or if you want to use the speaker with an external play-
back device.
• If selected ”Yes”, the display starts scanning for wireless
networks and shortly afterwards a list of available wire-
less networks is shown.
• The number of bars in the wireless symbol in front of the
network name (SSID) shows the relative signal strength
of the network.
• The key symbol indicates that the network is protected
by password.
• If the device does not find any wireless networks, “No
Wireless Networks Found” appears on the display. If
necessary change your location and check your WLAN
router.
Page 15