Table of Contents
Advertisement
Operating the appliance
en
1Operating the appliance
You have already learnt about the controls and how
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of scalding!
The water in the evaporator dish is still hot even after
the appliance has been switched off. Do not empty the
evaporator dish immediately after switching off the
appliance. Allow the appliance to cool down before
cleaning it.
Switching the appliance on and off
Before you are able to set the appliance, you must
switch it on.
The childproof lock and the timer can also be set
Note:
when the appliance is switched off. Certain displays and
notes, such as those relating to the residual heat in the
cooking compartment, remain visible on the display
after the appliance has been switched off.
Switch off your appliance when you do not need to use
it. If no settings are applied for a long time, the
appliance switches itself off automatically.
Switching on the appliance
Press the ÿ On/Off button to switch on the appliance.
All touch fields light up red. The Bosch logo appears on
the display, and then the first heating type in the
selection list.
Switching off the appliance
Press the ÿ On/Off button to switch off the appliance.
Any functions that may be running are cancelled.
The time, or if applicable, the residual heat indicator,
appears on the display.
In the basic settings, you can set whether the
Note:
clock should be displayed when the appliance is
switched off. ~ "Basic settings" on page 19
Starting the operation
You must press the l Start/Stop button to start each
operation.
After starting the appliance, the time display is shown
on the display along with the settings. The display ring
and the heating line also appear.
Pausing the operation
You can also interrupt and then continue an operation
using the l Start/Stop button.
If you press and hold the l Start/Stop button for
approx. 3 seconds, the operation is cancelled and all
settings are reset.
The fan may continue to run after an operation
Note:
has been paused or cancelled.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 19
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Fill the water tank before each use:
Open the appliance door.
1.
Remove the water tank from the water tank recess
2.
(picture
).
!
Fill the water tank with cold water up to the "max."
3.
mark. (Picture
).
"
Close the tank cover
4.
until you feel it engage.
Insert the filled water tank (picture
).
5.
#
Check whether the water tank is pushed in flush with
6.
the water tank recess (picture
).
$
Close the appliance
7.
door.
The water tank has been filled. You can now start the
operation.
Page 12
Advertisement
Table of Contents
