Siemens SIMATIC PCS 7 Operating Manual page 82

Functions
7.3 Device management
Inserting a DP device
PROFIBUS devices can be inserted directly into the PROFIBUS DP master system.
1. Select the device you require under "PROFIBUS DP" in the hardware catalog and drag it
Inserting a DP remote I/O system (distributed I/O)
Integration is described based on the example of ET 200iSP .
1. Place the head-end station "IM152-1" you have selected from the hardware catalog under
2. You can insert the required analog and digital modules in slot 4 and higher.
Inserting a PA device at a DP/PA coupler
1. Select a device in the PROFIBUS-PA folder of the hardware catalog.
2. Position it at the PROFIBUS DP master system.
Inserting a PA device at a DP/PA-Link
1. Place the "IM 153-2" you have selected from the hardware catalog under "PROFIBUS DP
2. Drag-and-drop the PA devices to this PA master system.
82
onto the DP master system.
"PROFIBUS DP > ET200iSP" at the DP master system.
The slots of the head-end station are displayed in the detail view in the table below the
graphic.
This can be, for example, a SITRANS P pressure transmitter listed under "PROFIBUS-PA
> Siemens > Sensors > Pressure > SITRANS P" or a device profile listed under "PROFIBUS-
PA > Other".
You have to select the device for some objects. You can find information on this in the
section ""Insert Object - Assign Device Type" dialog box (Page 79)".
Note
The DP/PA coupler does not need to be configured; you only need to set an appropriate
bus transmission rate (for example, 45.45 kbps for the Siemens coupler) for the DP master
system.
> DP/PA-Link" at the DP master system. (The IM 153-2 replaces the IM 157, but both types
can be used as PROFIBUS-Link ).
HW Config creates a PA master system for the DP/PA-Link .
For certain objects it is necessary to select the device. You can find information on this in
the section ""Insert Object - Assign Device Type" dialog box (Page 79)".
Help for SIMATIC PDM (V8.2)
Operating Manual, 02/2014, A5E33203676-AA