Creating Typicals For Parameters (Import Without Id Data) - Siemens SIMATIC PCS 7 Operating Manual

● Profile3
● Profile I&M
Basic preparation
1. Insert a number of objects for PROFIBUS profile devices of the appropriate type at the
2. Configure the ID data for the PROFIBUS devices in the object properties:
Commissioning PROFIBUS devices
1. Connect the PROFIBUS devices in the automation system.
2. Select a device configured as a placeholder in the process device network view or in HW
3. Download the configuration to the device (section "Download to device (Page 163)").
4. Assign the required device description to the device (section "Device selection (Reassign)
5. Where required modify the device's online parameters.
6. Load the data from the device into the configuration (section "Upload to PG/PC
7. Repeat steps 2 through 6 until all devices are configured.
8. Save the data in the project.
7.3.4

Creating typicals for parameters (import without ID data)

You can use the following procedure to assign the parameters of an already configured device
to identical devices.
Procedure
1. Open the process device network view.
2. Select a configured device or the network in which the configured devices are located.
3. In SIMATIC Manager, select the menu command Edit > SIMATIC PDM > Export.
Help for SIMATIC PDM (V8.2)
Operating Manual, 02/2014, A5E33203676-AA
desired addresses in the process device network view in a PROFIBUS PA network.
Examples:
– Sensor > Temperature > PROFILE3 > Profile3
– Siemens > SIEMENS > Profile I&M
– TAG
– Description
– Message
Config.
(Page 202)"). Recommendation: Use the "Device identification" function.
(Page 165)").
Functions
7.3 Device management
105