Using Dmi Tools - Acer M5-481TG Service Manual

Figure 2-37. Install File (QRDCIO_x64 folder shown)
5. Select iFFSModeViewer.exe file in Windows mode.
6. Run iFFSModeViewer.exe in Windows mode.
iFFSModeViewer menu opens on screen (Figure 2-38).
7. In the iFFSModeViewer screen, select iFFS Mode (see Figure 2-38).
Figure 2-38. IFFS Mode Viewer
The procedure is complete.
NOTE: NOTE:
To reset system to default, set Test Mode to Normal Mode.

Using DMI Tools

The DMI (Desktop Management Interface) Tool copies BIOS information to EEPROM. Used in
the DMI pool for hardware management.
When the BIOS shows Verifying DMI pool data, it is checking that the table correlates
with the hardware before sending it to the operating system (Windows, etc.).
WinPE and DOS Environments
As a prerequisite, a driver must be installed before running the DMI tools in WinPE. Skip these
steps, if you use DOS environment.
To install the driver, perform the following:
1. Boot to WinPE.
2-27 Acer M5-481TG System Utilities
0
0