Table of Contents
Advertisement
9 Troubleshooting
Warning
‡
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
UHTXHVWLQJ VHUYLFH ,I WKH SUREOHP UHPDLQV
unsolved, go to the Philips web site
(www.philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
‡
Ensure that the AC power plug of the unit
is connected properly.
‡
Ensure that there is power at the AC
outlet.
‡
To save power, the unit switches to
standby automatically 15 minutes after
a play reaches the end and no control is
operated.
No sound
‡
Adjust the volume.
No response from the unit
‡
Disconnect and reconnect the AC power
plug, then turn on the unit again.
Remote control does not work
‡
%HIRUH SUHVVLQJ DQ\ IXQFWLRQ EXWWRQ ÀUVW
select the correct source with the remote
control instead of the main unit.
‡
Reduce the distance between the remote
control and the unit.
‡
Insert the battery with its polarities
(+/– signs) aligned as indicated.
‡
Replace the batteries.
‡
Aim the remote control directly at the
sensor on the front of the unit.
18
EN
Downloaded From DvDPlayer-Manual.com Philips Manuals
No disc detected
‡
Insert a disc.
‡
Check if the disc is inserted with the print
side facing inward.
‡
Wait until the moisture condensation at
the lens has cleared.
‡
Replace or clean the disc.
‡
8VH D ÀQDOL]HG &' RU FRUUHFW IRUPDW GLVF
&DQQRW GLVSOD\ VRPH ÀOHV LQ 86% GHYLFH
‡
7KH QXPEHU RI IROGHUV RU ÀOHV LQ WKH 86%
device has exceeded a certain limit. This
phenomenon is not a malfunction.
‡
7KH IRUPDWV RI WKHVH ÀOHV DUH QRW
supported.
USB device not supported
‡
The USB device is incompatible with the
unit. Try another one.
Poor radio reception
‡
Increase the distance between the unit and
your TV or VCR.
‡
Fully extend and adjust the FM antenna.
Timer does not work
‡
Set the clock correctly.
‡
Switch on the timer.
Clock/timer setting erased
‡
Power has been interrupted or the power
cord has been disconnected.
‡
Reset the clock/timer.
Advertisement
Table of Contents
