Figure 8: Popit Label Placement For 9000 Series Control Panels; Figure 9: Popit Label Placement For D9112B1/D7212B1 Control Panels - Bosch D8125 Operation And Installation Manual

Zone expansion module

Hide thumbs Also See for D8125:

Installation and operation manual (40 pages)

Table Of Contents

Table of Contents

D8125

Installation

Point Label

To place the POPIT Labels in using the D7212B1 or D9112B1, use the labels with the part number 79-04252-000 and either

the sheet marked Vertical Grid for POPEX #1 for points 9 to 71 or the sheet marked Vertical Grid for POPEX #2 for Points 73

to 135. Refer to Figure 9.

POPIT Switch Settings Label

Figure 9: POPIT Label Placement for D9112B1/D7212B1 Control Panels

Each label has two parts. Place the smaller part, with just the point number on it, on the POPIT terminal block as shown in

Figure 8 and Figure 9. Place the larger part with the switch settings on the POPIT cover. Set the switches and cover the POPIT.

Do not program two POPITs for the same point number. After you program all the points, perform a walk test. The

Security System Owner's Manual (P/N: 74-06633-000) and the Security System User's Guide (P/N: 71-06141-000) contain

instructions for performing a walk test. If a point does not test, check the programming for a duplicated address.

74-04247-000-N

Peel off and place Point

Label on POPIT cover

Peel off and place

POPIT Switch

Settings Label

to cover this chip

0 1 2 3 4 5 6

POPIT Switch Settings Label