Blower Operation - Craftsman 125.16821 Operator's Manual

Operation (continued)

Blower Operation

WARNING: Always wear safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before using blower.
WARNING: Keep bystanders clear from blowing debris.
WARNING: Wear a dust mask if blowing creates dust that might be inhaled.
1
6
This Wet/Dry Vac has blowing
capabilities. To use the blower feature
follow the instructions listed below:
1. Verify that the power cord is
disconnected from the outlet. (Fig.1)
2. Make sure the collection tank is
empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into
the blowing port on the back side of
the power head. (Fig. 2)
5. Fit the desired attachment to the
hose. (Fig. 3)
2
3
7
4
6. Verify that the power switch is in the
'O' (OFF) position before plugging
the power cord into the outlet.
(Fig. 4, Fig. 5)
7. Before turning ON the vac, firmly
hold the loose end of the hose. Turn
the motor on by pressing the switch
to the 'I' (ON) position. (Fig. 6)
8. Once you have completed
vacuuming, press the power switch
to the 'O' (OFF) position and unplug
the power cord from the outlet.
(Fig. 7)
9
5