6.1 SERVICE FACTORY MODE
Service factory mode uses an OSD function of the Media Receiver (PDP-R03E or PDP-R03U).
Perform the adjustment and setting in the state that this unit and Media Receiver are connected by the system.
Plasma display cannot use a factory mode by being simple.
Remote Control Unit Operation in The Service Factory Mode
Operate the service factory mode with the remote control unit (AXD1463 or AXD1460) of accessory of the media receiver.
Please perform the adjustment by operating the following keys.
P + key
One line moves the selection cursor of the adjustment item up.
P – key
One line moves the selection cursor of the adjustment item down.
+1 raises a adjustment value
–1 reduces a adjustment value
Perform page down (previous page)
Perform page up (next page)
–10 reduces a adjustment value
+10 raises a adjustment value