114
Chapter 6
Troubleshooting
Error Messages
If you receive an error message, note the message and take the
corrective action. The following table lists the error messages in
alphabetical order together with the recommended course of
action.
Error Messages
CMOS Battery Bad
CMOS Checksum Error
Disk Boot Failure
Diskette Drive Controller Error
or No Controller Present
Diskette Drive Error
Diskette Drive Type Mismatch
Equipment Configuration Error
Hard Disk 0 Error
Hard Disk 0 Extended Type
Error
I/O Parity Error
Corrective Action
Contact your dealer or an authorized
service center.
Contact your dealer or an authorized
service center.
Insert a system (bootable) diskette in the
floppy drive (A:), then press Enter to
reboot.
Contact your dealer or an authorized
service center.
Contact your dealer or an authorized
service center.
Press F2 (during POST) to enter the BIOS
Utility; then press Esc to exit and
reconfigure the computer.
Press F2 (during POST) to enter the BIOS
Utility; then press Esc to exit and
reconfigure the computer.
Contact your dealer or an authorized
service center.
Contact your dealer or an authorized
service center.
Contact your dealer or an authorized
service center.