Chapter 2 Autoset 1500 Installation; Mounting The Autoset Control Enclosure - Honeywell AutoSet 1500 User Manual

Wintriss two-channel load analyzer
Table of Contents

Advertisement

Chapter 2
AutoSet 1500 Installation
Installation of AutoSet involves mounting the AutoSet control box and connecting wiring
for power, strain links, and other devices. This chapter covers:
Mounting the control box
Connecting AC wiring and stop circuit
Mounting and connecting strain links
Connecting AC wires to power source
Zero cam wiring (In some cases, installation of a zero cam switch is necessary)
Optional connections.

Mounting the AutoSet control enclosure

If you have a panel mount, go to Appendix A for special installation
instructions, and mounting and cutout dimensions.
1. Determine a convenient place for the control box. Ideally it should be close to the
press control so operators and setup personnel can easily see the readouts and
reach the reset button. Also make sure the strain link cables will reach to the
mounting site selected. Leave enough room to open the door at least 120°. The
box can be mounted to the press or on a free-standing pedestal.
2. Drill holes for mounting (see dimensions in Figure 2-1). Shockmount studs are
1/4–20. Tap holes (if necessary) and mount the box using the enclosed shock
mounts. Use a No. 7 drill and 1/4–20 tap.
AutoSet 1500 User Manual
IMPORTANT!
8 (20.32 )
L E F T
12.75
SETPOINTS
(32.39)
AutoSet
®
1500
W I N T R I S S LO A D A N A LY Z E R
Figure 2-1. AutoSet mounting dimensions
LOAD
R I G H T
ZER O C AM
RESET
7
Ch 2
1088500

Advertisement

Table of Contents
loading

Table of Contents