2. Basic Setting For Joystick; 2-1. Joystick Calibration; 2-2. Key Test; 2-3. Renew The Password - Sanyo Vsp-3000 Service Manual

2. BASIC SETTING FOR JOYSTICK

After assembling the product, it has to be set below
(especially, the AS of Main Board or Joystick)

2-1. JOYSTICK CALIBRATION:

Push No.3 + SUB MENU (3 sec), the it move to JOYSTICK CALIBRATION MODE
NO Joystick setting point
PTZ OFFSET
1
PAN LEFT
2
PAN RIGHT
3
TILT UP
4
TILT DOWN
5
ZOOM WIDE
6
ZOOM TELE
7

2-2. KEY TEST

Push No.3 + SUB MENU (3 sec),test each key button with LCD indication.

2-3. Renew the Password :

Put the PASS WORD5534 for master p/w and set the new one.
Method
Set the center of JOYSTICK
(PushENT without joystick movement)
Set the left end of JOYSTICK
(PushENT with joystick move left end)
Set the right end of JOYSTICK
(PushENT with joystick move right end)
Set the up end of JOYSTICK
(PushENT with joystick move up end)
Set the down end of JOYSTICK
(PushENT with joystick move down end)
Set the WIDE end of JOYSTICK - counterclockwise
(PushENT with joystick move WIDE end)
Set the TELE end of JOYSTICK -clockwise
(PushENT with joystick move TELE end)
- -
5