PIAGGIO MP3 500 i.e. SPORT Service Station Manual page 426

MP3 500 i.e. SPORT Business_LT_ ABS-ASR_EU_USA (2015)
Pre-delivery
Carry out the listed checks before delivering the motorcycle.
Warning - Handle fuel with care.
Fit the plastic cover supplied on the joint on the
steering tube as shown in the figure.
Proceed as follows if the customer requests in-
stallation of splash guards on the vehicle:
•
Fit the flap inside the mudguard shown
in the figure, matching up the 4 anchor
holes.
•
Fit the 4 washers and the 4 screws on
the outer side of the mudguard, then
tighten to the specified torque.
Locking torques (N*m)
splash guard fastener screws
ASR SYSTEM CALIBRATION PROCEDURE.
The calibration procedure of the system must be
carried out according to what is indicated below,
riding on a straight flat stretch of road. In order to
maintain the effectiveness of the ASR system, the
procedure must be carried out again after the re-
placement of one or more tyres:
• It is necessary that the diagnostic phase of the
ASR systems and ABS is complete: for this pur-
pose, after switching to «ON», ride a short dis-
tance above 5 km/h and wait for the flashing of the
two warning lights to stop.
• Allow the engine to idle for at least 5 seconds.
• Pull the brake lever and press the ASR on/off
button «1» simultaneously for at least 3 seconds.
The activation process will be confirmed by the
PRE DE - 426
2 - 3