PIAGGIO MP3 500 i.e. SPORT Service Station Manual page 376

Table of Contents

Advertisement

MP3 500 i.e. SPORT Business_LT_ ABS-ASR_EU_USA
Braking system
(2015)
- Lift the ABS modulator support to unscrew the
two lower fixing screws.
- Remove the ABS modulator.
MODULATOR INSTALLATION
To install the abs modulator, repeat the operations described in the removal in reverse order, paying
close attention when inserting the piping.
Then perform the system bleed, in order to reset the correct operation of the braking system.
Locking torques (N*m)
Pipe fittings - ABS control unit 13 - 18 Screw fixing ABS control unit to support 10 to 12 ABS
control unit supporting bracket fixing screw 8 ÷ 10
ASR
CAUTION
THE FOLLOWING INSTRUCTIONS REFER TO THE VEHICLE VERSION EQUIPPED WITH ABS -
ASR SYSTEM.
System ASR
ASR SYSTEM
The ASR system is a device to help riding that helps the rider during acceleration manoeuvres, espe-
cially on slippery surfaces or in conditions that can cause sudden slippage of the rear wheel. The ASR
in these situations automatically intervenes by reducing engine output within the limit imposed by the
grip conditions, contributing significantly to the maintenance of stability the vehicle.
WARNING
THE ASR SYSTEM IS BASED ON THE RECOGNITION OF SPEED DIFFERENCES BETWEEN
FRONT AND REAR WHEEL. IN ORDER FOR THE SYSTEM TO MAINTAIN MAXIMUM EFFICIENCY
IN ALL CONDITIONS, THE CALIBRATION PROCEDURE MUST BE PERFORMED EVERY TIME,
EVEN IN CASE OF REPLACEMENT OF JUST ONE TYRE.
FOR THE CALIBRATION OF THE CONTROL UNIT PERFORM THE PROCEDURE BELOW.
BRAK SYS - 376

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents