Switching On and
On or standby
Before you switch on the TV, make sure you plugged
in the mains power in the POWER connector on the
back of the TV.
With the TV in Standby, press
control to switch the TV on. You can also press the
small joystick key on the back of the TV to switch the
TV on in case you can't find the remote control or its
batteries are empty.
Switch to standby
To switch the TV to standby, press
control. You can also press the small joystick key on
the back of the TV.
In standby mode, the TV is still connected to the
mains power but consumes very little energy.
To switch off the TV completely, disconnect the
When disconnecting the power plug, always pull the
power plug, never the cord. Ensure that you have full
access to the power plug, power cord and outlet
socket at all times.
Keys on TV
If you lost the remote control or its batteries are
empty, you can still do some basic TV operations.
To open the basic menu...
1 - With the TV switched on, press the joystick key on
the back of the TV to bring up the basic menu.
2 - Press left or right to select Volume,
Channel or Sources. Select Demo, to start a
3 - Press up or down to adjust the volume or tune to
the next or previous channel. Press up or down to go
through the list of sources, including the tuner
selection. Press the joystick key to start the demo
on the remote
on the remote
4 - The menu will disappear automatically.
To switch the TV on standby, select and press the
With the Sleep Timer, you can set the TV to switch to
Standby automatically after a preset time.
To set the Sleep Timer...
1 - Press , select General settings > Sleep
timer and press OK.
2 - With the slider bar you can set the time to up to
180 minutes in increments of 5 minutes. If set to 0
minutes, the Sleep Timer is switched off. You can
always switch off your TV earlier or reset the time
during the countdown.
3 - Press BACK to close the menu.
Switch off timer
If the TV receives a TV signal but you don't press a
key on the remote control during a 4 hour period, the
TV switches off automatically to save energy. Also, if
the TV does not receive a TV signal nor a remote
control command for 10 minutes, the TV switches off
If you use the TV as a monitor or use a digital receiver
to watch TV (a Set-Top Box - STB) and you do not
use the remote control of the TV, you should
deactivate this automatic switch off.
To deactivate the Switch Off Timer ...
1 - Press , select Eco settings and
press (right) to enter the menu.
2 - Select Switch off timer and press OK.
3 - Press the arrows (up) or (down) to adjust
the value. The value 0 deactivates the automatic
4 - Press (left) repeatedly if necessary, to close
For more information on environmentally friendly TV
settings, in Help, press the colour