Download  Print this page

Synchronous Control Analysis Mode - Mitsubishi Electric QD77MS User Manual

Simple motion module.
Hide thumbs


5.4 Synchronous control analysis mode

With synchronous control analysis mode, parameters are only analyzed for synchronous
control when there is a command to start synchronous control. This mode is used to confirm
the synchronous positions of the output axes in order to align axes with position control
before starting synchronous control.
If the target axis bit is ON in "[Cd.381] Synchronous control analysis mode" when starting
synchronous control (turning the target axis bit from OFF to ON for "[Cd.380] Synchronous
control start"), operation enters synchronous control analysis mode.
When the synchronization position analysis is completed, the synchronous control monitor
data ([Md.400] to [Md.425]) is updated, and the target axis bit in "[Cd.380] Synchronous
control start" turns OFF.
The busy signal is not turned ON during synchronous control analysis mode.
When starting synchronous control with synchronous control analysis mode, the following
error does not occur.
• Cam axis feed current value restoration disable (error code: 769)
Cd.380 Synchronous control
(Target axis bit)
Cd.381 Synchronous control
analysis mode
(Target axis bit)
Synchronous control
monitor data
( Md.400 to Md.425 )
Positioning start
BUSY signal
(OFF during analyzing)
Axis operation status
The last monitor value
Check synchronization
position in synchronous
control analysis mode.
Chapter 5 Synchronous Control Initial Position
Monitor value at synchronous control start
Start positioning on the cam axis feed current value
at the beginning after checking the target axis bit of
Synchronous control start" is OFF.
control (8)
Move to the
synchronization position
with positioning control .
5 - 22
control (15)
Start synchronous control


Table of Contents

   Also See for Mitsubishi Electric QD77MS

   Related Manuals for Mitsubishi Electric QD77MS

   Related Content for Mitsubishi Electric QD77MS

This manual is also suitable for:


Comments to this Manuals

Symbols: 0
Latest comments: