Sets a language for the OSD menus. Use
your preferred language.
The projector will automatically shut down while there is
no signal input detected after the time you set.
Choose "On" to dim the projector LED brightness, which
will also lower the power consumption, reduce noise, and
extend the LED life. Choose "Off" to return to the normal
Selecting "On" enables the function. Both micro USB cable
inside the projector and the DC 5V out port/USB A port (if
available) on the back of the projector can output 5V
power when it is in standby mode.
USB 5V (Standby)
Choose "On" to turn on the High Altitude mode. When this
function is turned on, the projector fans operate at full
speed continuously to cool down the projector's
Selecting "On" enables the function. The projector will
AC Power On
automatically turn on when power is supplied via the
Firmware Version Displays current firmware version.
Enabling this function slightly increases the standby
Connect the projector to the internet using the
Acer eDisplayPro app.
Press "ENTER" after selecting "OTA" and the
projector will automatically search for the latest
firmware version available.
Select YES when the projector pops out a message
to remind you that there is a new firmware
version for you.
Do not turn off the projector while the firmware is