Rear Panel - Sony RMO-S594 User Manual

Rear Panel

1
Function switches
Use this switches to set the disk unit's
functions in accordance with the host
computer and software being used. Refer to
the section"Setting the Disk Unit's
Functions" on page 11 for more information.
2
SCSI ID switch
Use these switches to set the SCSI ID. Push
the "–" button to lower the ID number; push
the "+" button to raise the ID number. Refer
to the section"Setting the SCSI ID"on page
11 for more information.
3
SCSI connectors
Plug SCSI cables (sold separately) linking
the host computer and other SCSI peripherals
into these connectors.
Note:
If the disk unit is the last device on the SCSI
chain, set function switch F to "1" to turn on
the internal terminator. When it is not the last
device, make sure that the terminator is off
(switch F is set to "0").
8
Chapter 1 Introduction
A B C D E F G H
1
SCSI ID
0
SCSI CONNECTOR
2
1 3
Fig 1-3: Rear View
AC IN
F.GND
4 5 6
4
Air duct
The air for cooling the disk unit flows
through this duct, so be careful not to block
its surface or impede the outflow.
5
F.GND (frame ground) terminal
Connect the ground terminals of other
devices to the disk unit's frame ground.
6
AC IN (AC power) connector
Connect the supplied AC power cord to this
connector.