Operations - Bissell PET HAIL ERASER 1650 SERIES Quick Start User Manual

Operations

WARNING
Do not plug in your vacuum until you are familiar with all instructions and operating
procedures.
NOTE: Be sure the green suction knob on side of vacuum is turned to
"Floor Suction" before use.
1
Step gently on base and pull back on
handle to recline.
3
Turn Height
Adjustment Knob
to desired carpet
cleaning level.
NOTE: For optimal carpet cleaning performance, adjust to the lowest practical
setting. If your vacuum is difficult to push, adjust to the next higher setting.
NOTE: In the unlikely event that hair wrapped around your brush roll, run vacuum
back and forth on clean carpet several times to help release any wrapped hair.
NOTE: Turn off the brush roll when vacuuming hard or delicate surfaces that may
be caught by the rotating brush. This could include hard wood, tiled floors, small
area rugs or frieze carpets that have long delicate fibers or threads.
8
www.BISSELL.com
2
Power
On/O
Switch
Turn vacuum on by pressing Power Switch on
(I - ON and O - OFF). Press Brush roll switch to
run the PowerBrush for carpet cleaning (brush
roll is on when light on switch is illuminated).
See page 15 to maintain the brush roll.
NOTE: The brush roll will automatically shut off
when vacuum is locked in upright position,
recline to reactivate.
4
Utilize the clip on the
back of your vacuum to
hold the hose in place.
Pull out when using hose
with tool attachments.
Brushroll
On/O
Switch