Appendix 2: Declaration On Compliance With Fcc Regulations - Siemens CP 5613 A2 Product Information

Declaration of Compliance with FCC Regulations
The following declaration relates the products described in this manual unless
stated otherwise. The declaration for other products can be found in the documen-
tation of the relevant product.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules and complies all the require-
ments of the Canadian regulations for equipment that can cause electrical interfer-
ence (Canadian Interference-Causing Equipment Regulations). These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harm-
ful interference to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation.. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
●
Consult the dealer or an experienced radio or television technician for help.
● The manufacturer is not responsible for any radio or television interference
caused by unauthorized modification of this device or the substitution or at-
tachment of connecting cables and equipment other then specified by the
manufacturer. The correction of interference caused by such unauthorized
modification, substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required for connection of the device to all op-
tional I/O devices and host devices. Failure to meet this requirement can repre-
sent a violation of the FCC Rules.
Product Information/Installation Instructions CP 5613 A2, CP 5614 A2
A5E00779184
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Product Information/Installation Instructions CP 5613 A2, CP 5614 A2
45