Table of Contents
Advertisement
Available languages
Available languages
heater outlet.
Parts supplied
This product
Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Flush surface screw
Screw
(5 mm × 9 mm)
(2 mm × 4 mm)
(6 pcs.)
(1 pc.)
Installation using the screw holes
on the side of this product
• Fastening this product to the factory radio-
mounting bracket.
Position this product so that its screw holes are
aligned with the screw holes of the bracket, and
tighten the screws at three locations on each
side.
Use either the truss head screws (5 mm × 8
mm) or flush surface screws (5 mm × 9 mm),
depending on the shape of the bracket's screw
holes.
If the pawl interferes with installation,
you may bend it down out of the way.
1
3
2
Factory radio-mounting bracket
A
Dashboard or console
B
Truss head screw or flush surface screw
C
Be sure to use the screws supplied with
this product.
Fastening the detachable
faceplate
If you do not plan to remove the detachable
faceplate, the detachable faceplate can be
fastened with the supplied screw.
Screw (2 mm × 4 mm)
Installing the GPS
antenna
CAUTION
Do not cut the GPS antenna lead to shorten
it or use an extension to make it longer.
Altering the antenna cable could result in a
short circuit or malfunction and permanent
damage to this product.
Installation notes
• The antenna should be installed on a
level surface where radio waves will
be blocked as little as possible. Radio
waves cannot be received by the
antenna if reception from the satellite
is blocked.
Dashboard
Rear shelf
• When installing the GPS antenna inside
the vehicle, be sure to use the metal
sheet provided with your system. If this
is not used, the reception sensitivity
will be poor.
• Do not cut the accessory metal sheet.
This would reduce the sensitivity of the
GPS antenna.
• Take care not to pull the antenna lead
when removing the GPS antenna. The
lead may become detached.
• Do not paint the GPS antenna, as this
may affect its performance.
13
En
Hide quick links:
Advertisement
Chapters
Table of Contents
