Download  Print this page

Troubleshooting; Installation; What To Do If - Electrolux EHF6140FOK Use Manual

Hide thumbs


with vinegar and clean the glass
surface with a moist cloth.


Refer to Safety chapters.

7.1 What to do if...

You cannot activate or op‐
erate the hob.
Residual heat indicator
does not come on.
7.2 If you cannot find a
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass


Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
Serial number ...........................
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
The zone is not hot be‐
cause it operated only for a
short time.
surface). Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
8.3 Connection cable
• For a single phase or two phase
connection use the following (or
higher) mains cable type: H05V2V2-F
T min 90°C.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Refer to the
connection diagram.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.



  Also See for Electrolux EHF6140FOK

This manual is also suitable for: