Installing The Aileron Linkages - Phoenix Model Ka-8b ELECTRIC 6000 Instruction Manual

Instruction Manual
2. Repeat step # 1 - # 2 to install the control horn
on the opposite aileron.

INSTALLING THE AILERON LINKAGES

The aileron linkages are assembled as shown
below.
22mm
90mm
M3 nut
1. Plug the aileron servo into the receiver and
center the servo. Install the servo arm onto the
servo. The servo arm should be perpendicular
to the servo and point toward the middle of the
wing.
2. Center the aileron and hold it in place using a
couple of pieces of masking tape. Adjust the
linkage until the aileron and the servo arm are
both centered and then tighten the nut against
the clevis. Install the plastic linkball to the servo
arm. Remember use thread locking compound
to secure.
Link ball
22mm
9
10
M3 nut
11
3
Screw
Flat washer
Aluminum link ball
Plastic link ball
Servo arm
Flat washer
M3 nut
3. Repeat step 1 - step 2 for the second aileron
linkage.
INSTALLING THE electric air brakes
(not included with the kit)
1. Remove the covering from the top of the wing.
K8B
12
WING TIP
13