Honeywell DC1010 Product Manual page 5

4.3 Level 3
When LCK=0000, press SET key and SHIFT key for 5 seconds to enter level 3.
Main Control(INP1)
Input Selection
SET
Main Control(INP1)
Analog Zero set
SET
Main Control(INP1)
Analog Span set
SET
Decimal point
SET
Lower Set-point limit
SET
Upper Set-point limit
SET
Sub Control(INP2)
Analog Zero set
SET
Sub Control(INP2)
Analog Span set
SET
Alarm mode of AL1
SET
Time set of Alarm 1
SET
Alarm mode of AL2
SET
Time set of Alarm 2
SET
Alarm mode of AL3
SET
Time set of Alarm 3
SET
Hysterisis of Alarm
SET
DC1010/1020/1030/1040 PRODUCT MANUAL
Select the input range.
Refer to 5.1 Input selection on P.12~P.13
Used as input code which are AN1 to AN5
Range: LSPL~USPL
Same as ANL1
To set the position of decimal point
(Available for INP1=AN1 to AN5)
To set the lowest point within INP1
To set the highest point within INP1
Used as input code which are AN1 to AN5
Range: LSPL~USPL
Same as ANL2
Range: 00~19
Refer to '6.1 Alarm Function Selection' on P.14
Used in program function (Range: 0~99.59 min.)
0=flicker alarm, 99.59=continued, others = on delay time
* in Program Model, Alarm on time(ALD1=17)
Range: 00~19
Refer to '6.1 Alarm Function Selection' on P.14
Same as ALT 1
Range: 00~19
Refer to '6.1 Alarm Function Selection' on P.14
Same as ALT 1
Range: 0~1000
5
5