Table of Contents
Advertisement
1
1
2
2
4
4
3
3
Smartimer
The Smartimer indicates that your brushing cycle is complete by
automatically turning off the toothbrush at the end of the brushing cycle.
Dental professionals recommend brushing no less than 2 minutes twice a
day.xQuadpacer
-
The Quadpacer is an interval timer that has a short beep and pause to
remind you to brush the 4 sections of your mouth. Depending on the
brushing mode or brushing routine you have selected, the Quadpacer
beeps at different intervals during the brushing cycle. See the "Brushing
instructions" and "Personalizing your brushing experience" sections.
The Quadpacer feature on this model has been activated. To deactivate or
reactivate the Quadpacer feature:
1
Place the handle with a brush head attached in the plugged-in
charger.
To deactivate Quadpacer: Press and hold the Personalized brushing
button for seconds. You hear 1 beep to indicate the Quadpacer has
been deactivated.
To reactivate Quadpacer: Press and hold the Personalized brushing
,
button for seconds until you hear beeps. This indicates that the
Quadpacer feature is active again.
Note: The Quadpacer feature cannot be deactivated on the pre-programmed
Go Care and Max Care brushing routines.
Cord wrap on deluxe charger (select models)
If your model includes the deluxe charger cover and base, the travel
charger is pre-installed inside the cover. If you want to shorten the power
cord, you can store excess cord in the cord wrap feature built into the
charger base.
1
To separate the charger cover from the charger base, press the two
gray snap bars on the charger base and pull the white charger cover
upwards.
Wrap excess power cord around the gray charger base as shown in
the picture. Be sure to wrap the cord on the inside of the two snap
levers.
EngliSh
Advertisement
Table of Contents
