Download Print this page

Getting Started; Changing The Color Code Ring; Attaching The Brush Head; Charging Your Sonicare - Philips FlexCare HX6910 User Manual

Rechargeable sonic toothbrush
Hide thumbs


Table of Contents
4235.020.2275.6.indd 6

getting started

Changing the color code ring

Sonicare brush heads come with interchangeable color code rings to
identify your brush head.
To change the color code ring:
Pull the color code ring from the bottom of the brush head.
Install a new ring by slipping one edge of the new ring over the
bottom of the brush head. Then press down on the other side to
snap the ring in place.

Attaching the brush head

Align the brush head so the bristles face the front of the handle.
Firmly press the brush head down on the metal shaft until it stops.
Note: There is a small gap between the color code ring and the handle.

Charging your Sonicare

Plug the charger into a live outlet.
Place the handle on the charger.
The flashing light on the battery gauge indicates that the toothbrush
is charging.
Deluxe recharge gauge:
Indicates amount of charge left in battery
3 green LEDs: 75-100%
2 green LEDs: 50-74%
1 green LED: 25-49%
1 flashing yellow LED: less than 25%
Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1
LED on the recharge gauge flashes yellow for 30 seconds after the 2-minute
brushing cycle.
29-09-09 09:20

Hide quick links:


Table of Contents

  Also See for Philips FlexCare HX6910

  Related Manuals for Philips FlexCare HX6910