GE B90 Instruction Manual page 146

5.2 PRODUCT SETUP
The main reception menu is applicable to configurable GOOSE only and contains the configurable GOOSE dataset items
for reception:

PATH: SETTINGS PRODUCT SETUP
 
RECEPTION CONFIGURABLE GOOSE
 CONFIG GSE 1
 DATASET ITEMS
The configurable GOOSE settings allow the B90 to be configured to receive a number of different datasets within IEC
61850 GOOSE messages. Up to sixteen different configurable datasets can be configured for reception. This is useful for
intercommunication between B90 IEDs and devices from other manufacturers that support IEC 61850.
For intercommunication between B90 IEDs, the fixed (DNA/UserSt) dataset can be used. The DNA/UserSt dataset contains
the same DNA and UserSt bit pairs that are included in GSSE messages.
To set up a B90 to receive a configurable GOOSE dataset that contains two IEC 61850 single point status indications, the
following dataset items can be selected (for example, for configurable GOOSE dataset 1): "GGIO3.ST.Ind1.stVal" and
5
"GGIO3.ST.Ind2.stVal". The B90 will then create a dataset containing these two data items. The Boolean status values from
these data items can be utilized as remote input FlexLogic™ operands. First, the
must be set to contain dataset "GOOSEIn 1" (that is, the first configurable dataset). Then
must be set to "Dataset Item 1" and "Dataset Item 2". These remote input FlexLogic™ operands will then change state in
accordance with the status values of the data items in the configured dataset.
Double-point status values may be included in the GOOSE dataset. Received values are populated in the
GGIO3.ST.IndPos1.stVal and higher items.
The main menu for the IEC 61850 server configuration is shown below.

PATH: SETTINGS PRODUCT SETUP
 SERVER
 CONFIGURATION
The and
IED NAME LD INST
nodes are located. Valid characters for these values are upper and lowercase letters, numbers, and the underscore (_)
character, and the first character in the string must be a letter. This conforms to the IEC 61850 standard. The
variable string and can be composed of ASCII characters. This string appears within the PhyName of the LPHD node.
5-26

COMMUNICATIONS

CONFIGURABLE GOOSE 1(16)
ITEM 1:
GGIO3.ST.Ind1.stVal
ITEM 2:
MESSAGE
GGIO3.ST.IndPos1.stV
ITEM 3:
MESSAGE
None
ITEM 32:
MESSAGE
None

COMMUNICATIONS
IED NAME: IECDevice
LD INST: LDInst
MESSAGE
LOCATION: Location
MESSAGE
IEC/MMS TCP PORT
MESSAGE
NUMBER:
INCLUDE NON-IEC
MESSAGE
DATA: Enabled
SERVER SCANNING:
MESSAGE
Disabled
settings represent the MMS domain name (IEC 61850 logical device) where all IEC/MMS logical
B90 Low Impedance Bus Differential System
 
IEC 61850 PROTOCOL

CONFIG GSE 1(32) DATA ITEMS
Range: all valid MMS data item references for
transmitted data
Range: all valid MMS data item references for
transmitted data
Range: all valid MMS data item references for
transmitted data
↓
Range: all valid MMS data item references for
transmitted data
REMOTE DEVICE 1(16) DATASET
 
IEC 61850 PROTOCOL
Range: up to 32 alphanumeric characters
Range: up to 32 alphanumeric characters
Range: up to 80 alphanumeric characters
Range: 1 to 65535 in steps of 1
102
Range: Disabled, Enabled
Range: Disabled, Enabled
5 SETTINGS
GSSE/GOOSE CONFIGURATION
REMOTE IN 1(16) ITEM
SERVER CONFIGURATION
LOCATION
GE Multilin
setting
settings
is a