Philips **HFL5011T/12 Installation Manual page 37

 [Brightness at Low light]: Via a slider you
can change the brightness with a low light
input
 [Brightness at Intense Light]: Via a slider
you can change the brightness with an
intense light input
 [Light sensor Sensitivity]: Via a slider you
can change the light sensor sensitivity
Note: Above menus are only accessible
when [External Clock] is set to [On]
 Navigate to the [Welcome Logo] menu
 You will see below items:
o [Off]: You can disable the Welcome Logo
o [On]: You can enable the Welcome Logo
 The best resolution needs to be 1920x1080 for
xxHFL5011 and 3840X2160 for xxHFL7011
 How to upload the file in TV:
o Create your WelcomeLogo.jpg, this file should
be below 16MB. If the file cannot be played by
the TV it will not be loaded during the cloning
process
Save the file into to following folder on your
o
USB device (note the case sensitivity):
/TPM1532HE_CloneData/MasterCloneData/
WelcomeLogo/WelcomeLogo.jpg
/TPM1531HE_CloneData/MasterCloneData/
WelcomeLogo/WelcomeLogo.jpg
o Switch ON the TV, insert the USB with the new
content
o Go to [Professional settings] [Upgrade and
Clone] [Clone USB to TV] menu and press "OK"
to upload the picture in the TV
o Once done, exit [Professional settings] and
reboot the TV and check your changes
Note: You can do this using CMND as well
- 36 -
(xxHFL5011)
(xxHFL7011)