Local Operation" Screen Selection; Speed Control" Screen - Siemens SIMATIC HMI TP900 Operator's Manual

Screens

4.6 "Local Operation" screen selection

4.6 "Local Operation" screen selection
4.6.1

"Speed control" screen

You can change the speed of the motor during local operation in this screen.
Note
Enabling of the local operation
Local operation can only be enabled when the converter is not in operation.
Calling the screen
Press the <Local operation> button in the navigation bar. Select the "Speed Control" screen.
①
②
Figure 4-11
Changing the speed
1. Switch the converter on with the <Power> button.
2. Change the speed setpoint of the motor. The following options are available:
● Manual input via the keypad
● Step-by-step with the arrow keys
● The "0" button resets the speed setpoint to zero.
If the communication between the Control Unit and the operator panel is faulty, the converter
shuts down. A fault message is displayed in the "Overview" screen.
26
Speed change through input with the keypad
Step-by-step speed change with the arrow keys
Example: "Speed Control" screen
①
.
②
.
TP900 Function Manual
Function Manual, 10/2016, A5E39487277A