Eiki EK-800U Service Manual page 74

Chapter 5 Firmware Upgrade
4. Confirm Run as administrator & Close firewall
- Click "Next" to continue.
- Connect the projector to AC and power it on.
- When the source message is displayed on the
bottom left of the projected image, click Next.
5. Connect projector to computer
- Connect the RJ-45 cable to the projector and the
computer.
- Set the IP address of the computer to match
the first three numbers of the projector.
(for projector 192.168.000.100, set computer to
192.168.000.xxx where xxx is not 100)
- Click "Next" to continue.
5-4
EK-800U