Pstn Phone Calls; Making Pstn Call; Receiving Pstn Call; Transferring Pstn Call - D-Link DPH-70L User Manual

Modem ip phone

Table of Contents

DPH-70L User's Guide

6 PSTN Phone Calls

DPH-70L can make and receive normal PSTN phone calls. When DPH-70L is not connected to

the Internet through the VoIP button (RECEIVE state), it is known to be in idle state. In this state it

works as a normal phone, making and receiving PSTN phone calls. This feature does not need

any configuration.

To make an outgoing call, go off hook and dial the destination number, followed by 'ENTER'. For

example, you press 12345 ENTER to call 12345 through PSTN network. It plays various call

progress tone as in normal phone and plays ring back tone if the called party is free. DPH-70L

establishes the call on called party attending the call.

The dialing mode of PSTN number depends upon phone settings configuration. If blind dialing

mode is enabled, PSTN number is dialed in blind mode, and if pulse dial is enabled, PSTN

number is dialed in pulse mode. (Please refer section 7.3.7).

DPH-70L has special supports for operation behind an EPABX. For example, you may have to

dial 9 to get external dial tone and then dial the destination number. In this scenario, first dial '9

ENTER' to dial to EPABX and get external dial tone, then dial the destination number.

Warning:

DPH-70L identifies end of phone number by 'ENTER' key. Please terminate phone

number entry by pressing 'ENTER' key. If you don't press any key for more than 5 sec, DPH-70L

identifies it as end of phone number.

DPH-70L can receive any normal PSTN phone call when DPH-70L is not connected to the

Internet through the VoIP button. It rings on incoming call and establishes call on off hook. Either

party can disconnect the call by going on hook.

This feature allows the user to transfer a PSTN phone call to any PSTN phone. To transfer the

call, you flash the hook for a short period and dial the destination number followed by 'ENTER'

key. The destination number will ring and on off-hook the call transfer will be complete.

Table of Contents