Download  Print this page

Adjusting The Table Insert - Black & Decker JT2504BD Instruction Manual

10 in. portable table saw
Hide thumbs

Advertisement

Table of Contents
BB
3

ADJUSTING THE TABLE INSERT

(FIGURE CC)
WARNING
To avoid serious injury,
!
the table insert (1) must be level with
the table. If the table insert is not flush
with the table, adjust the two bolts (2)
with a 4 mm hex wrench until it is
parallel with the table.
NOTE: To raise the insert, turn the hex
screws counterclockwise, to lower the
insert, turn the hex screws clockwise. Do
not remove the insert, adjustments need
to be made with the insert in place to get
the proper level.
CC
2
ADJUSTING THE 90° AND 45° POSTIVE
STOPS (FIGURE DD, EE)
Your saw has positive stops that will
quickly position the saw blade at 90° and
45° to the table. Make adjustments only if
necessary.
90° Stop
• Disconnect the saw from the power
source.
• Raise the blade to the maximum height
position.
• Loosen the blade lock knob and move
the blade to the maximum vertical
position and tighten the blade lock
knob.
• Place a combination square on the
2
• If the blade is not 90° to the table,
1
4
• Loosen the blade lock knob and reset
• Check again to see if the blade is 90°
1
45° Stop
• Disconnect the saw from the power
• Raise the blade to the maximum height
• Loosen the blade lock knob and move
• Place a combination square on the
• If the blade is not 45° to the table,
• Loosen the blade lock knob and reset
24
table and against the blade (1) to
determine if the blade is 90° to the
table. (Figure DD)
loosen or tighten (depending on
whether you are increasing or
decreasing the degrees) the hex
bolt (3) with a 5 mm hex wrench until
blade achieves 90°. (Figure EE)
the blade at the maximum vertical
position, then tighten the blade lock
knob.
to the table. If not, repeat above two
steps.
DD
90°
1
source.
position.
the blade to the maximum bevel
position and tighten the blade lock
knob.
table and against the blade (2) to
determine if the blade is 45° to the
table. (Figure DD)
loosen or tighten (depending on whether
you are increasing or decreasing the
degrees) the hex bolt (4) with a 5 mm
hex wrench until blade achieves 45°.
(Figure EE)
the blade at the maximum bevel
position (45°), then tighten the blade
lock knob.
45°
2

Advertisement

Table of Contents
loading

  Related Manuals for Black & Decker JT2504BD