Advertisement

SERVICE MANUAL
Ver. 1.2 2007.05
Speaker section
Speaker system
48 mm, Full range, magnetically shielded
Enclosure type
Bass reflex
Impedance
4 Ω
Rated input power
3 W
Maximum input power
6 W
Amplifier section
Rated output
3 W + 3 W (10% T.H.D., 1 kHz, 4 Ω)
Bass Boost
MEGA BASS
Audio input
Stereo minijack × 1
Input impedance
4.7 kΩ (at 1 kHz)
General
Power
Three R6 (size AA) batteries, DC 5.2V
(supplied AC power adaptor)
Dimensions (w/h/d)
Approx. 280 × 111 × 140 mm
× 4
× 5
(11
1
/
3
/
5
/
in.)
8
8
8
Sony Corporation
9-887-439-03
Personal Audio Division
2007E16-1
Published by Sony Techno Create Corporation
© 2007.05
SRS-BTM30
SPECIFICATIONS
Mass
Approx. 750 g (1 lb. 10 oz.) including batteries
Communication System
BLUETOOTH Specification version 2.0
Output
BLUETOOTH Specification Power Class 2
Maximum communication range
Line of sight approx. 10 m (30 ft)*
1
Frequency band
2.4 GHz band (2.4000 GHz–2.4835 GHz)
Modulation method
FHSS
Compatible BLUETOOTH Profiles*
A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio/Visual Remote Control Profile)
Volume UP/DOWN
3
Supported Codecs*
4
SBC*
, MP3
*
1
The actual range will vary depending on
factors such as obstacles between devices,
magnetic fields around a microwave oven,
static electricity, reception sensitivity, aerial's
performance, operating system, software
application, etc.
*
2
BLUETOOTH standard profiles indicate the
purpose of BLUETOOTH communication
between devices.
*
3
Codec: Audio signal compression and
conversion format
4
*
Subband Codec
WIRELESS SPEAKER SYSTEM
Canadian Model
AEP Model
Australian Model
Supplied accessories
AC Power Cord (Mains lead) (1)
AC power adaptor (1)
Operating Instructions (1)
Optional accessories
Connecting cord RK-G136, RK-G138
Plug adaptor PC-234S, PC-236MS
The above optional accessories are not provided
in some areas.
2
Design and specifications are subject to change
without notice.
The Bluetooth word mark and logos are owned
by the Bluetooth SIG, Inc. and any use of such
marks by Sony Corporation is under license.
Other trademarks and trade names are those of
their respective owners.
MPEG Layer-3 audio coding technology and
patents licensed from Fraunhofer IIS and
Thomson.
US Model
UK Model
E Model

Advertisement

Table of Contents
loading

Summary of Contents for Sony SRS-BTM30

  • Page 1 MEGA BASS by the Bluetooth SIG, Inc. and any use of such SBC* , MP3 marks by Sony Corporation is under license. Audio input Stereo minijack × 1 Other trademarks and trade names are those of The actual range will vary depending on their respective owners.
  • Page 2: Table Of Contents

    LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
  • Page 3: General

    SRS-BTM30 SECTION 1 GENERAL This section is extracted from instruction manual. 1 1 (power) button/indicator 5 DC IN 5.2 V jack Press to turn on the unit. Press and Connects the supplied AC power hold to turn off the unit.
  • Page 4: Pairing With A Source Device

    • When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other. • Some devices cannot display the list of detected devices. Select “SRS-BTM30” shown in the display of the BLUETOOTH stereo audio source device.
  • Page 5: What Is Bluetooth Technology

    SRS-BTM30 When pairing with a BLUETOOTH stereo audio source device that cannot display a list of detected devices or that has no display You may pair the device by setting both this unit and the BLUETOOTH stereo audio source device to pairing mode.
  • Page 6: Disassembly Flow

    SRS-BTM30 SECTION 2 DISASSEMBLY Note: Disassemble the unit in the order as shown below. 2-1. DISASSEMBLY FLOW 2-2. FRONT CABINET ASSY, REAR CABINET ASSY (Page 7) 2-3. AMP BOARD 2-6. REAR CABINET (Page 8) SUB ASSY (Page 9) 2-4. BT BOARD (Page 8) 2-5.
  • Page 7: Front Cabinet Assy, Rear Cabinet Assy

    SRS-BTM30 Note: Follow the disassembly procedure in the numerical order given. 2-2. FRONT CABINET ASSY, REAR CABINET ASSY 2 two tapping screws (+P 2.6 × 8) 3 back panel 1 battery case lid 4 three tapping screws (+P 2.6 × 8) 5 three tapping screws (+P 2.6 ×...
  • Page 8: Amp Board

    SRS-BTM30 2-3. AMP BOARD PRECAUTION DURING AMP BOARD INSTALLATION 1 four tapping screws (+P B2.6) D603 AMP board 6 AMP board 11mm D602 2 wire (flat type) 13core (CN801) 3 connector 17mm (CN301) 5 flexible flat cable 24core (CN101) 4 connector...
  • Page 9: Speaker Sub Assy

    SRS-BTM30 2-5. SPEAKER SUB ASSY 5 four tapping screws (+BV B3) 3 four packing sheets (w) 6 speaker sub assy 4 four tapping screws (+BV B3) red cable black cable 7 speaker sub assy black cable red cable 2 two notches...
  • Page 10 SRS-BTM30 SECTION 3 DIAGRAMS NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. Note on Printed Wiring Boards. Note on Schematic Diagrams. • All capacitors are in µF unless otherwise noted. (p: pF) 50 WV or • X : parts extracted from the component side.
  • Page 11: Block Diagram

    SRS-BTM30 3-1. BLOCK DIAGRAM J901 INPUT IC202 IC101 IC201,Q203 IC301 AUDIO AMP POWER AMP LOUT FILTER 1 IN+ SHUTDOWN S502 ROUT VOLUME R-CH SPK301 SPEAKER IC311 Q201 Q202 S503 POWER AMP ID SET IC102 S504 BUFFER Q301 BT BOARD IC702...
  • Page 12: Printed Wiring Board - Amp Board (Side A)

    SRS-BTM30 Ver. 1.1 3-2. PRINTED WIRING BOARD – AMP BOARD (SIDE A) – :Uses unleaded solder. C409 FB402 FB303 D402 D301 FB404 TP301 C306 FB301 R610 C207 C607 Q301 VDR402 R217 VDR301 R214 C208 FB401 D302 C605 TP402 C305 3 4 5...
  • Page 13: Printed Wiring Board - Amp Board (Side B)

    SRS-BTM30 Ver. 1.1 3-3. PRINTED WIRING BOARD – AMP BOARD (SIDE B) – :Uses unleaded solder. VOLUME S501 S502 S503 S504 R303 R403 C513 C215 R225 C705 Q201 D602 C212 C512 C214 C514 C213 Q202 C203 IC703 R703 R206 R313...
  • Page 14: Schematic Diagram - Amp Board (1/2)

    SRS-BTM30 3-4. SCHEMATIC DIAGRAM – AMP BOARD (1/2) – • See page 17 for IC Block Diagram. C126 R103 R117 C124 C103 R109 R112 R104 C122 C105 100p 0.001 R108 R111 C127 R116 C120 C106 R107 100p C109 C108 R114 R110 0.022...
  • Page 15: Schematic Diagram - Amp Board (2/2)

    SRS-BTM30 Ver. 1.1 3-5. SCHEMATIC DIAGRAM – AMP BOARD (2/2) – • See page 17 for IC Block Diagrams. C201 R201 C204 0.47 R208 R202 R212 C202 4.7k 330p C205 IC301 R210 R209 IC TPA2010D1YZFR 2.2k R211 C608 R611 R227...
  • Page 16: Printed Wiring Board - Jack Board

    SRS-BTM30 Ver. 1.1 3-6. PRINTED WIRING BOARD – JACK BOARD – :Uses unleaded solder. 3-7. SCHEMATIC DIAGRAM – JACK BOARD – CN901 AMP BOARD TP913 CN801 (Page 12) TP912 J901 TP911 TP910 CN901 TP909 FB904 TP908 TP913 TP908 TP904 FB901...
  • Page 17 SRS-BTM30 • IC Block Diagrams – AMP Board – IC101 SM6451BT-G-E2 1/2 VDD Chip Address Decoder Attenuation Control Reference Interface Control Attenuation Decoder Voltage Circuits Attenuation Control 1/2 VDD IC301, IC311, IC401, IC411 TPA2010D1YZFR 150 k *Gain = *Gain = 2 V/V...
  • Page 18: Exploded Views

    SRS-BTM30 Ver. 1.1 SECTION 4 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they may have some difference from the original are seldom required for routine service. one.
  • Page 19: Electrical Parts List

    SRS-BTM30 Ver. 1.2 SECTION 5 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • RESISTORS When indicating parts by reference number, parts list may be different from the parts All resistors are in ohms. please include the board name.
  • Page 20 SRS-BTM30 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark C506 1-165-908-11 CERAMIC CHIP FB106 1-216-864-11 SHORT CHIP C507 1-164-245-11 CERAMIC CHIP 0.015uF FB107 1-216-864-11 SHORT CHIP FB301 1-469-324-21 INDUCTOR (EMI FERRITE) (2012) C508 1-164-245-11 CERAMIC CHIP 0.015uF...
  • Page 21 SRS-BTM30 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < RESISTOR > R411 1-216-841-11 METAL CHIP 1/10W R412 1-216-841-11 METAL CHIP 1/10W R101 1-216-844-11 METAL CHIP 1/10W R413 1-216-864-11 SHORT CHIP R102 1-216-844-11 METAL CHIP 1/10W...
  • Page 22 SRS-BTM30 Ver. 1.2 JACK Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < SWITCH > ACCESSORIES ************ S501 1-554-088-00 SWITCH, KEY BOARD (VOLUME+) S502 1-554-088-00 SWITCH, KEY BOARD (VOLUME–) 1-478-852-13 ADAPTOR, AC (AEP, UK) S503 1-554-088-00 SWITCH, KEY BOARD (ID SET)
  • Page 23 SRS-BTM30 MEMO...
  • Page 24: Revision History

    SRS-BTM30 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2006.10...

Table of Contents