Troubleshooting - Electrolux TW L4 E User Manual

Hide thumbs Also See for TW L4 E:
Table of Contents

Advertisement

Available languages

Available languages

74 electrolux

TROUBLESHOOTING

TROUBLESHOOTING
1)
Problem
The tumble dryer is not connected to
mains supply.
The loading door is opened.
The tumble
dryer does
The On/Off button was not pushed.
not operate.
The Start/Pause button was not push-
ed.
The appliance is in the standby mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in minimum
mode.
Unsatisfactory
The heat exchanger filters are clogged.
drying results.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the drum.
Too high water hardness.
The filter not locked in the position.
The door
does not
The laundry is locked between the door
close.
and the seal.
You try to change the programme or the
function after the start of the cycle.
Err (Error) on
The function you try to activate is not
the display.
applicable with the selected pro-
gramme.
No drum light
Defective drum light.
5)
Abnormally
The time to end is calculated on the ba-
elapsing time
sis of the volume and dampness of the
on the dis-
laundry.
play.
Programme
The water container is full.
inactive.
Too small laundry volume.
Drying cycle
too short.
The laundry is too dry.
The filter is clogged.
Drying cycle
6)
too long
Too high volume of the load.
Possible cause
Remedy
Connect in at mains socket. Check fuse
in fuse box (domestic installation).
Close the loading door.
Push the On/Off button.
Push the Start/Pause button.
Push the On/Off button.
Do the selection of the applicable pro-
2)
gramme.
3)
Clean the filter.
Change the Dry Plus function to the
moderate or maximum mode.
Clean the heat exchanger filters.
Obey the maximum load volume.
Clean the airflow grill in the bottom of
the appliance.
Clean the inner surface of the drum.
Set applicable water hardness
Put the filter in the correct position.
Put the load correctly in the drum.
Turn the tumble dryer off and on. Make
the new selection.
Turn the tumble dryer off and on. Make
the new selection.
Contact the service centre to replace
the drum light.
The automatic procedure — this is not
the appliance malfunction.
Drain the water container
Start/Pause button.
Do the selection of time programme.
The time value must be related to the
load. To dry one item or small quantities
of the laundry we recommend to use
short times.
Do the selection of time programme or
higher drying level (e.g. Extra Dry )
Clean the filter.
Obey the maximum load volume.
3)
4)
.
3)
, push the

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents