Advertisement
INSTALLING THE CBS-2121 POUR OVER COFFEE BREWER
Congratulations on your purchase of the new FETCO CBS-2121!
CAUTION
– This brewer is shipped with the thermostat turned ON.
DO NOT plug in unit before pouring 3 pots or 192 oz. of water into the opening until brewer is full
(
Note step 5, below); damage to the heating element or thermostat may result if started when dry.
Remove any protective vinyl film-if present, from the stainless steel enclosure. The protective film pulls off.
1. Place coffee brewer on a solid, level counter top, near an electrical outlet.
Full brewer and dispensers weighs 28.4 pounds
2.Level the brewer: Use a bubble level and check side-to-side and also front-to-back
-Do not plug in the power cord at this time
3. Place an empty glass decanter on the lower warmer deck, under the brew basket.
4. Insert the empty brew basket into the brew rails of the brewer.
5. Slowly fill the tank with room temperature water through the opening on the top cover until water starts
running in a steady stream from the brew basket (3 pots or 192 fl.oz.). This indicates that the tank is full and
primed for brewing.
6. Plug the power cord into the electrical outlet.
7. Allow the brewer to heat up to full temperature, indicated by the "READY" light on front panel.
-Slight dripping from the brew basket is normal as water expands when heated.
-Keep an empty carafe under the brew head to collect any possible drips.
-Heat up may take up to 30 minutes for the first time the coffee brewer is plugged in.
-WHEN "READY" LIGHT IS ON.
8. Insert the empty brew basket into the brew rails of the brewer.
9. Place an empty decanter on the lower warmer deck, under the brew basket.
10. Run one additional carafe of fresh water to prime the hot water tank.
11. When "READY" light comes back on-the CBS-2121 is ready to brew
-PREWARMING THE DISPENSER
RECCOMMENDED FOR FIRST BREW OF THE DAY
-Running a "Blank-Brew"
For best heat retention and flavor – pre-warm stainless steel or glass dispensers before first brew.
With dispenser in place and with a clean empty brew basket—pour in plain water as in brewing.
This will pre-heat and rinse both the decanter and the brew basket, preparing it for the first brew.
-You are now ready to brew a regular batch
Load filter and fresh ground coffee into brew basket and brew when "READY" light is on.
To Start Up A New Unit:
.
DISPENSER PREHEATING
3
P155
REV:003
April - 2017
Advertisement
