Dial Edit; Calling Party Number; F-Route Setting For Ip Address - NEC 124i Enhanced Installation Manual

The system makes the call on a VoIP
trunk with the edited number by F-Route.

Dial Edit

ARS and F-Route have the ability to edit dialed digits. The edited dial digits are placed in the called party number area of the Setup
message.This dialed digit editing may be required to match the numbering plan of the remote telephone equipment.

Calling Party Number

If you need to send the calling party number, use the following programs.
Program 0406 Item 80 ISDN Calling Party Number
Program1031 ISDN Calling Number for Extensions
Program 0925 Calling Number for ISDN Trunks

F-Route Setting for IP Address

The following example explains how to set up F-Route. With this programming, you can dial 401 to access another node and the IP
address would be 192.178.10.2.
Program the VoIP PCB Operating Mode
In 0319, assign the slot number in which the VoIP PCB is installed.
Program the Hardware Settings for the VoIP.
In 0153, set the following:
Item 1:
IP Address: System A = 192.178.10.1
Subnet Mask: 255.255.0.0
Default Gateway Address: 192.178.10.10
Item 5:
Fast Connect Mode: Fast Connect (Mode 2)
Program the VoIP Trunk Group.
In Program 0905, assign VoIP trunks to the same trunk group 10.
VoIP Using F-Route and No Gatekeeper for
To place an outgoing call, a user dials the
F-Route code plus the telephone number.
The system waits for the F-Route digits.
Does the outgoing trunk
group have IP settings in
Yes
Stop
System B = 192.178.10.2
Outgoing Calls
Start
Program 0928?
The system follows the F-Route
programming or, if F-Route is not set,
the call is not completed.
No
Stop
Page 5