Using The Remote Control - Philips DVDR3360H User Manual

Remote Control

Using the remote control

A
Open the battery compartment.
B
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
C
Close the cover.
CAUTION!
– Remove batteries if they are
exhausted or if the remote control
is not to be used for a long time.
– Do not mix batteries (old and new
or carbon and alkaline, etc.).
– Batteries contain chemical
substances, so they should be
disposed of properly.
14
(continued)
Using the remote control to
operate the system
A
Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
B
Select the desired function
(for example
C
To control other devices
using this remote control,
press SELECT DEVICE
to select the mode
you wish to control (for
example SACD, TV).
will light up on the LED panel for a few
seconds to confi rm your selection.
Using the alphanumeric keypad to
enter the characters
– Press a number button repeatedly until
the required character or the number
appears.
– To enter language-dependent
characters, press
corresponding character, e.g.,: 'å' press
button {2} for 'a' and then press
'å' appears.
– To enter special symbols, press button
{1} repeatedly.
– To select upper/lower case (capital/
small) letters, press a/A.
– To enter a space, press button {1}.
, ).
The selected source mode
or on the
until