Table of Contents
Advertisement
Example:
CARE AND
CLEANING
Food is to cook for 2½ hours at 350°F. You wish
Gas Burners and Cooktop
the food to be cooked by 6:00.
Clean the surface burners as necessary-with
1. Press the COOK TIME pad.
warm soapy water. Remove any stubborn soil by
2. Turn the SET knob until 2:30 (2 hours, 30
soaking the burner, then scouring it with a
minutes) appears in the display,
powdered cleanser or a soap-filled scouring pad.
Clean the gas ports with a straight pin. Do not
enlarge or distort the ports. Do not use a
SET
E.2LI
©
wooden toothpick since it may break off and clog
the port.
Do not clean the burners with any of the
following caustic cleaners: commercial oven
cleaner, dishwasher detergent, or metal polishes.
3. Press the OVEN STOP pad.
These will damage the finish. Do not clean the
burners in the dishwasher.
4. Turn the SET knob until 6:00 appears in the
display.
The burner and burner tube must be dry before
use. They can be dried in an oven set on Warm.
5. Press the OVEN TEMP pad.
6. Turn the SET knob until 300° appears in the
Porcelain
Cooktop
display.
The eooktop on your range is designed with two
contoured wells which contain spills until they
can be wiped up.
All spillovers, especially acidic spillovers, should
be wiped up as soon as possible with a dry cloth.
To prevent possible cracking or chipping of the
porcelain, never wipe a warm or hot surface with
a damp cloth. Once the surface is cool, clean
with warm, sudsy water.
The oven will turn on at 3:30, cook the food for
Do not use abrasive or caustic cleaning agents on
2½ hours and will automatically turn off at 6:00.
the porcelain finish for they will permanently
damage the finish.
Additional
Information:
Lift Up Cooktop
The Electronic Control will continuously beep if
Your Maytag range features an "upswept"
you delay in entering a complete program. If you
cooktop that can be lifted up for convenient
hear the beeps, just continue entering the
access to the area under the eooktop. The top is
program as described. When the control is
hinged and can be raised but not removed.
properly set, the signal will stop.
To lift upswept
eooktop: When cool, grasp the
front edge of the cook-top and gently lift up until
To reset or cancel the program:
press the
the two automatic prop rods at the front of the
CANCEL pad.
cooktop snap into place.
To lower the eooktop:
Hold the front edge of
the cooktop and carefully push back on each
prop rod to release the notched support. Then
gently lower the top into place. The prop rods
will slide into the range frame.
PAGE 17
Advertisement
Table of Contents
