Setting Items For Scanning Using Operation Panel - Canon MB5100 Series Online Manual

Setting Items for Scanning Using Operation Panel

You can change the scan settings such as the scan size, resolution, or data format.
When the Scan standby screen is displayed, tap Settings to select the setting item. Flick vertically or tap
to display setting items and tap the setting item to display the settings. Tap to specify the setting.
Note
• When you forward the scanned data to the computer using WSD (one of the network protocols
supported in Windows 10, Windows 8.1, Windows 8, Windows 7, and Windows Vista), you cannot
specify the scan setting.
• Depending on the destination, some setting items cannot be selected. This section describes the
setting items when you select USB flash drive on the screen for selecting to which you save the data.
The setting item which cannot be selected is displayed grayed out.
• Some settings cannot be specified in combination with the setting of other setting item, the document
type selected for Doc.type, or the scan menu on the screen for selecting to which you save the data. If
the setting which cannot be specified in combination is selected,
the touch screen. In this case, tap
change the setting.
• The specified scan settings other than ADF orientation and ADF duplex scan such as the scan size,
resolution, and data format are retained even if the printer is turned off.
• When scanning starts in the scan menu that is not available with the specified setting, The specified
function is not available with current settings. is displayed on the touch screen. Change the setting,
following the on-screen instructions.
• For setting items or procedure for scanning from the computer:
• For Windows:
Settings Dialog Box
Using IJ Scan Utility
• For Mac OS:
Settings Dialog
Using IJ Scan Utility
1. Scan size
Select the size of the original.
2. Format
on the upper left on the touch screen to check the message and
730
and Error details are displayed on