Servicing Your Transceiver; Specifications - Uniden BearTracker 885 Owner's Manual

Problem
Poor Reception
No Transmission
Low Transmission
Unit does not work as well as
previously.
No GPS Signal
If you do not get satisfactory results after performing these checks, visit
the Uniden website (www.uniden.com) for troubleshooting and FAQ
information.

SERVICING YOUR TRANSCEIVER

It is the user's responsibility to see that this radio is operating at all times
in accordance with the FCC Citizens Radio Service regulations. We highly
recommend that you consult a qualified radio/telephone technician for
servicing and aligning this CB radio product.
When ordering parts, be sure to specify the correct model
number and serial number of the unit.

SPECIFICATIONS

Channel:
Frequency Range:
Microphone
Internal Speaker
Emission
Frequency Control:
Suggestion
Check VOLUME and SQUELCH.
Be sure antenna SWR is normal.
Adjust RF Gain.
Set CB/PA/WX|WX.ALT to CB.
Check microphone connection.
Adjust MIC Gain.
Adjust MIC Gain.
Turn the power off then back on. The channels
will reset.
Check RJ45 jack connections.
Examine GPS module and look for any
damage.
GENERAL
CB: 40 AM (4W)
Scanner: FM Only
CB : 26.965 ~ 27.405 MHz
SCN: 25 ~ 960 MHz
WX : 162.400 - 162.550 MHz
600 ohms, Dynamic Type
16 ohms, 5W Max
Emission AM/USB/LSB
PLL Synthesizer
E-29