Safety Notes - Bosch AXT RAPID 2000 Original Instructions Manual

Safety Notes

Warning: Read these instructions care-
fully, be familiar with the controls and
proper use of the machine. Please keep
the instructions safe for later use. Before
using for the first time, ask for a practical
demonstration.
Read instruction manual.
Danger – rotating blades, keep hands and
feet out of openings while the machine is
running.
Before handling the cutter, switch off and re-
move the plug from the mains supply. If the
cable is damaged or cut through while work-
ing, do not touch the cable but immediately re-
move the plug from the mains supply. Never
use the machine with a damaged cable.
Do not operate this equipment in the vicinity
of bystanders. Keep bystanders a safe dis-
tance away from the machine.
Wait untill all machine components have
completely stopped before touching them.
STOP
Do not expose the machine to rain. Only
store the machine in a dry place.
Wear protective gloves, sturdy shoes and
long trousers.
Obtain and wear eye and ear pro-
tection at all times while operating
the machine.
Dispose of this product in an environmen-
tally friendly way.
During operation, do not reach into the feed in-
take 1 or the discharge chute 8. The machine
runs on for a few seconds after being switched
off.
Before switching on, the machine must be assem-
bled according to the enclosed instructions.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
Use only extension cables that are intended for out-
door use and are protected against splashes of wa-
ter.
Do not touch the plug or socket with wet hands.
Do not drive over, crush or stretch the cable.
12 • F 016 L70 461 • TMS • 23.11.10
This appliance is not intended for used by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Other persons and animals should remain at a dis-
tance of 3 metres or more when the machine is be-
ing used. The operator is responsible for third per-
sons in the working area.
Bosch can assure flawless functioning of the ma-
chine only when original accessories are used.
Become familiar with the owner's manual before at-
tempting to operate this machine.
Avoid wearing loose-fitting clothing, hanging cords
or ties.
Only operate the machine in open space (eg not too
close to a wall or other fixed objects) and on a firm,
level surface.
Do not operate the machine on paved or gravel sur-
face where ejected material could cause injury.
Before starting the machine, check that all screws,
nuts, bolts and other fasteners are properly secured
and that guards and screens are in place. Replace
damaged or unreadable warning and operating labels.
Before starting the machine, make certain that the
feed intake is empty.
Keep your face and body away from the feed intake.
Do not allow hands or any other part of the body or
clothing inside the feed intake, discharge chute or
near any moving part. Switch off the machine before
attaching or removing the bag.
Keep proper balance and footing at all times. Do not
overreach.
Never stand at a higher level than the base of the
machine when feeding material.
Always stand clear of the discharge zone when op-
erating the machine.
When feeding material into the machine be ex-
tremely careful that pieces of metal, rocks, bottles,
cans or other foreign objects are not included.
If the cutting mechanism strikes any foreign object or
if the machine should start making any unusual
noise or vibration, immediately switch off and allow
the cutter to stop. Remove the plug from the mains
supply and take the following steps:
– Inspect for damage.
– Replace or repair any damaged parts.
– Check for and tighten any loose parts.
English - 1