A location subject to temperature and
•
humidity extremes, whether low or high
A location subject to dramatic changes in
•
temperature or humidity
A location near equipment that generates
•
magnetic or electromagnetic waves
A laboratory or location where chemical
•
reactions occur
A location exposed to corrosive or toxic gases
•
A location that may warp from the weight of
•
the machine or where the machine is liable to
sink (a carpet, etc.)
Avoid poorly ventilated locations
This machine generates a slight amount of ozone
and other emissions during normal use. These
emissions are not harmful to health. However,
they may be noticeable during extended use or
long production runs in poorly ventilated rooms.
To maintain a comfortable working environment,
it is recommended that the room where the
machine operates be appropriately ventilated.
Also avoid locations where people would be
exposed to emissions from the machine.
Do not install in a location where
condensation occurs
Water droplets (condensation) may form inside
the machine when the room where the machine
is installed is heated rapidly, and when the
machine is moved from a cool or dry location to
a hot or humid location. Using the machine
under these conditions may result in paper jams,
poor print quality, or damage to the machine.
Let the machine adjust to the ambient
temperature and humidity for at least 2 hours
before use.
In altitudes of above sea level 3,000 m or higher
Machines with a hard disk may not operate
properly when used at high altitudes of about
3,000 meters above sea level, or higher.
Leveling feet (only for products with leveling
feet)
Do not remove the machine’s leveling feet after
the machine has been installed, as this may
cause the machine to fall or tip over, resulting in
personal injury.
Connecting the Telephone Line (Only for
Products with a Fax Function)
This machine conforms to a analog telephone
line standard. The machine can be connected to
the public switched telephone network (PSTN)
only. If you connect the machine to a digital
telephone line or a dedicated telephone line, it
might impede proper operation of the machine
and could be the cause of damage. Make sure to
confi rm a type of telephone line before
connecting the machine. Contact your optical
fi ber line or IP telephone line service providers if
you want to connect the machine to those
telephone lines.
When using wireless LAN (only for products
with a wireless LAN function)
Install the machine at a distance of 50 meters
•
or less from the wireless LAN router.
As far as possible, install in a location where
•
communication is not blocked by intervening
objects. The signal may be degraded when
passing through walls or fl oors.
Keep the machine as far as possible from
•
digital cordless phones, microwave ovens, or
other equipment that emits radio waves.
Do not use near medical equipment. Radio
•
waves emitted from this machine may
interfere with medical equipment, which may
result in malfunctions and accidents.