Canon PIXMA MP760 Service Manual page 44

#6 GENESIS (UHQ)
(Genesis function settings)
#7 PRINTER
(Printer function settings)
Caution: #6 GENESIS (UHQ function settings)
Tampering with this setting may cause the scanned image quality to deteriorate.
Do not change these settings.
Memo:
#7 PRINTER (Printer function settings)
1. At #5 INK ABS CAPA, you can check or register the capacity of waste ink ejected during the
cleaning operation.
(%) with the numeric keys.
The absorption amount of the waste ink absorber is set based upon the amount that the BJ
cartridge has ejected.
The settings of the waste ink capacity are stored in EEPROM of SPCNT BOARD.
When replacing the SPCNT BOARD, check the waste ink capacity before the replacement,
and register the waste ink capacity at the new SPCNT BOARD after the replacement.
2. At #6 CDR ADJUST (CD-R Print writing pos ition adjustment), you can adjust the writing
position in X and Y directions within the following range.
+/-0.0mm, +/-0.1mm, +/-0.2mm, +/-0 .4mm, +/-0.6mm, +/-0.8mm, +/-1.0mm
You can also perform this adjustment from "CD-LabelPrint" or "Easy-PhotoPrint".
1.Bit SW
2.SLICE
3.GAMMA
#1 SSSW
Bit 7 6 5 4 3 2 1 0
SW01 – – – – – – – –
Not used
SW02~05:
SW06
– – – – – 1 0 0
SW07~20: Not used
SW20
#2 NUMERIC Param
#3 PRINT COUNT
#4 PRINTER RESET
#5 INK ABS CAPA
#6 CDR ADJUST
Figure 1-28 Service Data (3/4)
For the waste ink capacity registration, register a value between 0 – 100
1 - 37
Not used
Reduction settings
01: 18 (mm) Not used
02: 0
Not used
03: 0 Not used
04: 0
Leading edge margin
05: 5 (mm) Trailing edge margin (Black printing)
Item 06~30:
Not used
30:
XXX/YYY Print counter check
Yes=(-) Printer section reset function
No=(+)
SUCTION Wasteinkcapacitycheck/entry
[0]: CDR X SET
[1]: CDR Y SET