before using your Kenwood
Read these instructions carefully
and retain for future reference.
Remove all packaging and any
Watch out for steam, never
lift the filter holder lid
during the brewing cycle.
Never touch the hotplate or
Always lift the filter holder
lid using the handle at the
Do not touch hot parts including the
cup warming tray/filter holder lid
Never let the cord hang down
where a child could grab it.
Never use a damaged appliance.
Get it checked or repaired: see
'service and customer care'.
Never put the appliance in water or
let the cord or plug get wet - you
could get an electric shock.
before filling with water
Never leave the appliance on
Do not let the cord touch hot parts.
Always make sure there is water in
the tank before switching on.
This coffee maker is only suitable
for use with the type of carafe
Do not leave the appliance
switched on with an empty carafe
on the hotplate.
Never put the carafe in the
Downloaded from CoffeeMachineManual.com Manuals
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
ensure that they do not play with
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper
use, or failure to comply with these
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your appliance.
Important (UK) only
The wires in the cord are coloured
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
The appliance must be protected
by a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.